Lamy Peak

also known as San Juan Mountains

2,846 m 9,337 ft

Hiking Technical –/7 Altitude Moderate

Mountain in New Mexico, United States of America

Elevation
2,846 m 9,337 ft
source: our correction, see data notes
1 other figure
Oxygen on the summit
≈ 70% of sea level · High altitude
Type
Mountain
Country
United States (US, NM)
State
New Mexico
Coordinates
36.7608, -106.0956

Why climb Lamy Peak?

A little-known summit in the hills of northern New Mexico near San Antonio Mountain; of interest mainly to peakbaggers working through obscure named tops.

Obscure 2,846 m summit in Rio Arriba County, New Mexico; no published route was found, so the non-technical day-hike category is an unverified assumption.

Dangers and challenges

No route description, trail or trip report was found for this summit; anyone going should research land ownership and access locally first.

Routes

No routes recorded yet.

Weather forecast

Loading forecast…

More forecasts: US National Weather Service · yr.no · meteoblue · Windy · Mountain-Forecast.com
Avalanche danger: US avalanche centers — always read the current bulletin.

Compare Lamy Peak with…

Suggestions: Mount Etna similar hiking peak Baekdu Mountain similar hiking peak Mount St. Helens similar hiking peak San Antonio Mountain nearest higher peak

Map and nearby peaks

PeakElevationDistance
Los Cerritos De La Cruz2,838 m6.4 km
Red Hill2,649 m7.0 km
Broke Off Mountain3,156 m8.9 km
No Agua Peaks2,785 m12.1 km
San Antonio Mountain3,326 m12.9 km
Jawbone Mountain3,231 m13.0 km
Tusas Mountain3,100 m13.0 km
La Segita Peaks2,662 m13.8 km
Burned Mountain3,111 m13.9 km
Pinabetal Mesa2,764 m14.6 km
Quartzite Peak2,994 m16.4 km
Kiowa Mountain2,968 m18.2 km

Sources

AI-assisted research from the cited sources (November 2026, confidence: low). Figures marked estimate are not official counts. Always check current conditions and local advice before you go.

  1. TopoQuest - Lamy Peak, Rio Arriba County, NM (USGS GNIS summit)
  2. Wikidata - Lamy Peak

Data notes

Where sources disagree we show the value from our main data source and note the conflict. All data notes

Elsewhere